A spray arch can fit inside an existing pool without adding a square metre to its footprint. Once it starts spraying, though, water that used to sit in the basin travels through the air and lands on the deck. If you manage a Peterborough indoor pool and are pricing a feature like this, have the project team review the existing Seresco dehumidifier before you approve the purchase.
Give the designer a picture of your busiest hour
Mark the proposed spray pattern and splash zone on the pool drawing. Include the supplier’s flow rate, nozzle layout, run time per activation and whether guests can restart the feature immediately. A push-button arch that runs for thirty seconds at a time could run almost continuously during a busy family swim. Ask the designer to allow for that possibility.
A pump rating tells you how much water circulates through the feature. Only a portion of it evaporates into the room. Seresco’s Natatorium Design Guide explains why exposed water area and the movement of air and water matter when estimating evaporation. Ask the designer to identify which figures came from the supplier and which required an estimate.
Compare the proposed load with the installed unit
Find the Seresco model and serial number and, if available, the original equipment selection sheet. Give the designer the pool water temperature, room temperature and humidity that your team actually maintains. Include a log from a busy swim and a quieter period. If the room already struggles on Saturday afternoons, flag that before anyone counts on spare capacity.
Ask for two estimates side by side in the same units, such as kilograms of water per hour. How much moisture must the system remove during the busiest existing swim, and how much with the spray feature running at the same time? Have the designer compare both figures with the unit’s moisture-removal capacity at the proposed room conditions. If the decision depends on a timer or a limit on simultaneous features, put that condition into the purchase specification.
Agree on an opening-week check
Before installation, decide who will record room humidity, water and air temperatures, swim attendance and feature run times during the first busy session. Take a follow-up reading after the spray stops. Agree with the designer on the expected humidity range, recovery time and whom to call if the room falls outside those expectations. That gives staff a practical way to check the assumptions behind the purchase.
Planning a water feature at a Peterborough indoor pool? Call King Air at 905-939-0777 with the Seresco nameplate and the supplier’s feature drawing to discuss a retrofit assessment. Explore King Air’s Seresco dehumidifier services.
